Re: Unidentified subject!
- To: MISC
- Subject: Re: Unidentified subject!
- From: bagpiper@xxxxxxxxxx (Michael Hunter)
- Date: Sun, 20 Nov 1994 11:57:12 -0800 (PST)
- In-Reply-To: <199411170329.TAA23108@netcom16.netcom.com> from "Jeff Fox" at Nov 16, 94 07:29:45 pm
> The $350 system is fully assembled and has a simm. The $100 kit is a board,
> MuP21, UVPROM, and I think a part list and manual, and diskette. I
> don't think you get all the sockets, xtal, resistors, etc in the kit.
Any doc on the *exact* difference between these two products?
An estimate of the cost to realize the $100 kit into a product might
answer most of my question :)
> connect 8 buttons (one for reset) and a monitor, and power. The
> software source is for DOS under an FPC version of Chuck's assembler
> for MuP21. So you get Chuck's Forth assembler with OK as an
> example and library of routines. You can also get a different
Is source for these available? I don't like haveing to use MeSsy DOG.
mph
--
* Michael Hunter bagpiper@netcom.com or QUICS: mphunter
