PAL/SECAM signal generation with MuP21

[Penio Penev <penev@xxxxxxx>]

On Tue, 15 Nov 1994, Jeff Fox wrote:

> This highly integrated multiprocessor chip needs little supporting hardware to
> form a low cost, low power, high performance computer.  A minimum configuration
> consists of a MuP21, five 1Mx4 DRAM chips, and an 8-bit boot ROM.  An external
> 14 MHz crystal clock is needed only to synchronize the NTSC signal.

What about PAL/SECAM signal generation? I know, that the format of the 
frame is programable, so one would be able to describe it. But will the 
same xtal do the job?

In general, what is a good, definive book on video signal formats. It would
be great if the book was a little bit more, than a refference manual and
contained some discussion of the design goals and implementation decisions of
each format. 

--
Penio Penev <Penev@venezia.Rockefeller.edu> 1-212-327-7423